Wallpaper can instantly transform a space. Paper can transform a room from bland to bright in just a few hours. You can add texture or pattern to your walls or both. It can also mask minor imperfections in plaster or drywall.
However, homeowners who attempt to hang their papers by themselves often fail. John Gregoras is a professional paper hanger from Somers, New York. He has nearly two decades of experience. We asked Gregoras for his top wallpapering tips and tricks, including how to paste, hang, align, trim, and trim. We learned a lot, from how he plans the layout to how it is laid out. This kind of insider Glasvezelbehang kopen knowledge makes papering much easier.
When hanging wallpaper, the layout is critical. Your pattern will look straight and match perfectly if you pay attention to how the paper is laid. John Gregoras suggests that you work in the same direction as the pattern to maintain consistency.
Regardless of how skilled you are at your craft, the pattern between the first strip and the last strip will not match up. Gregoras starts behind a door and continues to paper from the corner until he reaches the area above the door. This is the most visible spot in the room. Peel off the wallpaper. To remove curls, inspect the wallpaper and place it against your worktable.
The paper should be cut into sheets 4 inches larger than your walls. It would be best if you missed the repeat in the same spot so that the patterns on the adjacent sheets align. Place a sheet of cut paper on top of the table. Apply a thin layer of transparent pre-mixed wallpaper paste to the back of the form using a paint roller. The pasted paper should be folded over itself, with the top and bottom edges meeting in the middle. Check that the sides are perfectly aligned. Smoothen the form as much as possible without creasing the folds.
To allow the paste to saturate the paper, place the piece aside. Follow the recommended booking time on the wallpaper’s label. It varies depending on the content of the wallpaper (more for vinyl-coated wallcoverings and less for uncoated papers). Begin in a corner close to a door. Draw a line parallel to the door if it is not in the corner.
Hang the book paper on the wall by unfolding the top. The book paper should be about 2 inches in front of the ceiling and about 1/8 inch at the corner. It should be lightly pressed in place. Let the book hang by unfolding the bottom. Verify the distance between the paper (or reference line) and the door casing. Adjust the form, so it is parallel to the door but not too far in the corner.
After aligning the sheet, you can use the edge of the paper smoother to fold the form in the corner towards the ceiling. Next, work from the top to sweep the report smoother across the entire sheet. The excess piece near the roof can be cut by inserting a 6-inch tape knife in the joint between the wall and ceiling. Use a razor to remove the extra paper. Slowly. Alternate cutting and moving the blade. Don’t slide the knife and razor together. Continue to form until you reach a point just above the door.